ISQ Monitor
Menu
IS3™
Monitor Osseointegration. Enhance decisions about when to load.
The IS3™ Osseointegration Monitor by OSSTEM Implant gives you objective and accurate ISQ measurements to help determine implant stability. These measurements serve as your support when deciding if immediate loading or proceeding with implant restoration is the best option for your patient
MulTipeg™
This is the peg that’s inserted into the implant being measured
MulTipeg™ Driver
The driver is used to attach the MulTipeg to the implant using 6 to 8Ncm of torque
IS3™ Hand-Held Unit
This instrument’s tip is held close to the top of the MulTipeg
Charger
The IS3 system is delivered together with a charger
Implant dentistry of today is trending toward either short or no healing periods before implant loading. This has shown great success rates among patients who prefer not to wait long periods for osseointegration to occur. However, this places a higher demand on your clinical team to ensure conditions are optimal. If not, poor primary stability increases the risk of implant failure.
Guidance and Predictability
· Raise the implant success ratio with accurate diagnostic.
· Confidence to decide the optimal loading time.
High Risk Area* Sucess Ratio:
· Bruxism 71.7%
· Diabetes 71.4%
· Immediate Loading 77.5%
· Iliac Crest Block + GBR + Sinus Graft 50%
· Surgeons <5 years experience had 5x failure
Hardening Time Alarming Function
Minimum Variance
* ISC International Standard Calibration
Optimal Physical Fit
IS3 MulTipeg™ (#74)
Reusable MulTipeg™
· Up to 20 times without any deviation.
· Reusable, autoclavable, calibrated, and compatible with all major implant systems.
MulTipeg™ (Titanium)
MulTipeg™ Driver
Optimized Patient Care
· Determines optimal loading protocol.
· The higher the ISQ Value, the higher the stability of the implant.
Ease of Use
· Hand held instrument with single key operation.
· Clear numeric displays on both sides and long-lasting rechargeable batteries
Product System and Practical Use
The IS3™ system consists of a hand-held instrument and a reusable MulTipeg™. A charger is delivered together with the instrument as well as a stainless steel driver for attaching the MulTipeg™ to the implant.
Step 1
Select the correct MulTipegTM for the implant being measured.
Step 2
Attach the MulTipeg™ Using the driver. (Hand-tighten, 6-8 Ncm of torque)
Step 3
Turn on the instrument and hold the tip of the instrument close to the top of the MulTipegTM.
Step 4
The instrument emits a beeping sound when it starts measuring and another sound when the ISQ value is presented on the display a second later.